Steps of Analysis, Design, and Detailing of Structure in ETABS

 

Steps of Analysis, Design, and Detailing of Structure in ETABS

Please Enable Desktop Mode when visiting with a Mobile Phone

STEPS	DESCRIPTION
1	Read architectural drawings and Column to Column Spacing
2	Input grid data
3	Define materials
4	Define frame section with property modifier (Beam, Column, Slab, Wall)
5	Draw member (Beam, Column, Slab, wall)
6	Assign support on base
7	Assign diaphragm
8	Define load pattern (Dead, live, PW, FF, EX, EY, WX, WY)
9	Define Load Case
10	Define mass source
11	Apply Loads
12	Load Combinations
13	Check Code & Framing Category
14	Assign mesh (frame, floor)
15	Set load case to run
16	Check the model and analysis
17	Displacement check
18	Eccentricity check
19	BASE SHEAR CHECK
20	Torsional irregularity check
21	P delta Check
22	Storey Drift Check for Seismic
23	Storey Drift Check for Wind
24	Overturning Check
25	Mass Irregularity Check
26	Sway Limitation
27	Soft Story
28	Design column, beam, slab
29	Detailing Column reinforcement in AutoCAD
30	Detailing Beam reinforcement in AutoCAD
31	Detailing Slab reinforcement in AutoCAD
32	Design Foundation (Isolated, Combined, Mat, Pile)
33	Detailing Foundation in CAD